Mitsumi electronic 55K PU jog operation, Start Press, Stop Press, Motor is decelerated to a stop

OPERATION/CONTROL

3.4.3PU operation mode

(Operation using the operation panel (FR-DU04))

(1) Operation at 60Hz

While the motor is running, repeat the following steps 2 and 3 to vary the speed:

Step			Description	Image
	Power-on → Operation mode check
	Switch power on and make sure that the operation command indication "PU" is lit.			ON
	(If it is not lit, press the MODE key to choose the operation mode and press the
1		key to switch to PU operation. For operation mode changing, refer to page				FR-DU04	CONTROL PANEL
	49.)
						MON	EXT	PU
							REV	FWD
	Running frequency setting
	Set the running frequency to 60Hz.			(or)
	First, press the MODE key to select the frequency setting mode. Then, press the
2		key to change the setting, and press the SET key to write the frequency.				FR-DU04	CONTROL PANEL
								Hz
								A
								V
						MON	EXT	PU
							REV	FWD
	Start
	Press the	FWD or REV	key.	FWD (or) REV
	The motor starts running. The monitoring mode is automatically selected and the
3	output frequency is displayed.					FR-DU04	CONTROL PANEL
								Hz
								A
								V
						MON	EXT	PU
							REV	FWD
	Stop
	Press the	STOP	key.
		RESET
	The motor is decelerated to a stop.			FR-DU04	CONTROL PANEL
						Hz
4						A
						V
				MON	EXT	PU
					REV	FWD

(2) PU jog operation

3

Hold down the FWD or REV key to perform operation, and release it to stop.

1)Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".

2)Select the PU jog operation. (Press the MODE key to choose the operation mode and press the key to switch to PU JOG operation.)

3)Hold down the FWD or REV key to perform operation.

(If the motor remains stopped, check Pr. 13 "starting frequency". The motor will not start if its setting is lower than the starting frequency.)

58