Mitsumi electronic 55K, FR-F520-0.75K instruction manual Parameter setting method

OPERATION/CONTROL

3.2.5Parameter setting method

•A parameter value may either be set by updating its parameter number or setting the value digit-by-digit

using the key.

•To write the setting, change it and press the SET key 1.5 seconds.

Example: To change the Pr. 79 "operation mode selection" setting from "2" (external operation mode) to "1" (PU operation mode)

(For details of Pr.79, refer to page 105.) Press the MODE key, to choose the parameter setting mode.

#Parameter setting mode

FR-DU04	CONTROL PANEL			Most significant			Least significant
		Hz
				digit flickers		Middle digit flickers	digit flickers
		A
		V	SET		SET
MON	EXT	PU
	REV	FWD

MODE

To 3.2.6 Operation mode

⋅ 7 times or

⋅ 3 times

⋅ 9 times or

⋅ 1 times

#Current setting #Setting change

0 to 9

SET

0 to 9

SET

		Press for
		1.5 s						3
		SET
	#Setting write
				MON EXT			PU
		When	appears		REV		FWD
		1) When the [FWD] or [REV] indication is lit,
		stop operation by pressing the				STOP		key
						RESET
		or turning off the forward rotation (STF)
		or reverse rotation (STR) signal connected
Flicker		to the control terminal.

2)You cannot set any value that is outside the parameter setting range. Write a value within the setting range.

"1" (PU operation mode) has been set in Pr. 79.

If the value and do not flicker but appears, you did not press the SET key

for 1.5 seconds when writing the value.

Press the key once, press the SET key, and restart the setting from the beginning.

48