Mitsumi electronic 55K, FR-F520-0.75K Response time, = Data sending time s, Number of Bits

PARAMETERS

5)Waiting time

Specify the waiting time between the receipt of data at the inverter from the computer and the transmission of reply data. Set the waiting time in accordance with the response time of the computer between 0 and 150ms in 10ms increments (e.g. 1 = 10ms, 2 = 20ms).

Computer	Inverter data processing time
↓
	= waiting time	+ data check time
Inverter	(set value⋅ 10ms)	(12ms)

Inverter

↓

Computer

Note: If the Pr. 123 "waiting time setting" value is not 9999, create the communication request data with no "waiting time" in the data format. (The number of characters is decremented by 1.)

6) Response time

Data sending time

(refer to the following calculation expression)

Inverter data processing time = waiting time + data check time

(set value 10ms) (12ms)

Computer

Inverter	STX	ACK	ENQ
Inverter		10ms or	10ms or
Computer		more required	more required

Data sending time

(refer to the following calculation expression)

Data sending time

(refer to the following calculation expression)

	Inverter data processing time = waiting time + data check time
Computer				(set value 10ms) (12ms)
Inverter
			ENQ
Inverter		10ms or
Computer		more required

Data sending time

(refer to the following calculation expression)

[Data sending time calculation expression]
1			Number of data characters	Communication specification		4
				(Total number of bits)	= Data sending time (s)
Communication speed
			(Refer to page 111)
	(bps)			(See below)
Communication specification
	Name		Number of Bits
	Stop bit length		1 bit
			2 bits
	Data length		7 bits
			8 bits
	Parity check	Yes	1 bit
		No	0 bits

In addition to the bits in the above table, 1 bit is required for the start bit.

Minimum total number of bits ... 9 bits

Maximum total number of bits ... 12 bits

113