Mitsumi electronic FR-F520-0.75K, 55K Output terminal function selection Pr to Pr

PARAMETERS

4.2.49 Output terminal function selection (Pr. 190 to Pr. 195)

Pr. 190 "RUN terminal function selection"

Pr. 191 "SU terminal function selection"

Pr. 192 "IPF terminal function selection"

Pr. 193 "OL terminal function selection"

Pr. 194 "FU terminal function selection"

Pr. 195 "A, B, C terminal function selection"

You can change the functions of the open collector and contact output terminals.

Parameter	Terminal	Factory	Factory-Set	Setting Range
Number	Symbol	Setting	Terminal Function
190	RUN	0	Inverter running	0 to 5, 8, 10, 11,
191	SU	1	Up to frequency	13 to 19, 25, 26,
192	IPF	2	Instantaneous power	98 to 105, 108,
			failure/undervoltage	110, 111,
193	OL	3	Overload alarm	113 to 116,
194	FU	4	Output frequency	125, 126, 198,
			detedtion	199, 9999
195	A, B, C	99	Alarm output	(40 to 48 Note)

Note: Setting may be made for the NA and EC versions only.

<Setting>

Refer to the following table and set the parameters:

Setting		Signal			Related
Positive	Negative		Function	Operation
		Name			parameter
logic	logic
0	100	RUN	Inverter running	Output during operation when the inverter output	
				frequency rises to or above the starting frequency.
1	101	SU	Up to frequency	Refer to Pr. 41 "up-to-frequency sensitivity". (Note	Pr. 41
				1)
2	102	IPF	Instantaneous power failure or	Output when an instantaneous power failure or	
			undervoltage	undervoltage occurs.
					Pr. 22, Pr. 23,
3	103	OL	Overload alarm	Output while stall prevention function is activated.	Pr. 66, Pr. 148,
					Pr. 149,Pr. 154
4	104	FU	Output frequency detection	Refer to Pr. 42, Pr. 43 (output frequency	Pr. 42, Pr. 43
				detection).
5	105	FU2	Second output frequency	Refer to Pr. 50 (second output frequency	Pr. 50
			detection	detection).
			Electronic overcurrent	Output when the cumulative electronic
8	108	THP		overcurrent protection value reaches 85% of the	Pr. 9
			protection pre-alarm
				preset level.
10	110	PU	PU operation mode	Output when the PU operation mode is selected.	
11	111	RY	Inverter operation ready	Output when the inverter can be started by	
				switching the start signal on or while it is running.
13	113	Y13	Zero current detection	Refer to Pr. 152 and Pr. 153 (zero current	Pr. 152, Pr. 153
				detection).
14	114	FDN	PID lower limit
15	115	FUP	PID upper limit	Refer to Pr. 128 to Pr. 134 (PID control).	Pr. 128 to
16	116	RL	PID forward-reverse rotation		Pr. 134
			output

140