Polycom 3725-76302-001LI Field Description Shared Signaling, Network Settings, General System

Network Settings Local Cluster Configuration

Table 4-1	Fields on the Network Settings page (continued)
Field		Description
Shared Signaling		The settings in this section are enabled only if
Network Settings		management and signaling traffic are on separate
		networks. If so, they apply to the entire system (both
		servers in two-server configuration).
		For a one-server configuration, the virtual host name
		and IP fields are disabled. (Exception: If only IPv6 is
		enabled, the system must have two addresses, so a
		single-server system must still have a virtual host name
		and IP address.)
		The settings are the same as those in Shared
		Management Network Settings, except that under
		Signaling Link, the signaling network interface (eth2)
		can be disabled. This capability exists for debugging
		purposes.
		The eth2 interface corresponds with the GB3 jack on
		the server.
		(The eth1 interface, which corresponds with the GB2
		jack, is reserved for the private network connection
		between the two servers in a two-server cluster.)
General System		The settings in this section apply to the entire system
Network Settings		and aren’t specific to management or signaling.
DNS search domains		One or more fully qualified domain names, separated by
		commas or spaces. The system domain you enter
		below is added automatically, so you need not enter it.
DNS 1		IP addresses of up to three domain name servers. We
		strongly recommend specifying at least one DNS
DNS 2
		server. A DNS server must be specified in order to
		connect to the Active Directory. See “Microsoft Active
DNS 3
		Directory Integration” on page 163.
Domain		Fully qualified domain name for the system.

Polycom, Inc. 67