Polycom 3725-76302-001LI manual To upload a backup file

Backing Up and Restoring System Management and Maintenance

3In the Actions list, click Create New (Full) to create a full backup or Create New (Config Only) to create a configuration-only backup (no transaction data).

A confirmation dialog tells you the backup archive was created. For a full backup, this may take some time.

4Click OK.

To upload a backup file

1Go to Maintenance > Backup and Restore.

2Verify that the oldest backup file listed is one you don’t want to keep or have already downloaded.

Only ten files are saved. Uploading a backup will delete the oldest file (unless there are fewer than ten).

3In the Actions list, click Upload.

4Choose a backup file to upload and click Open.

The File Upload dialog box indicates when the upload is complete.

5Click Close.

The system asks if you want to restore now from the backup file you just uploaded.

6If you don’t want to restore (and restart the system) now, click Manually Later. When you’re ready to restore, use the procedure that follows this one.

7To restore now, make sure you meet the criteria in the first two steps of the next procedure, and click Now. When asked to confirm, click Yes.

A dialog box informs you when all files have been restored.

8Click OK.

The system logs you out and the server reboots (typically, this takes about five minutes). After it comes back up, in a two-server cluster, the second server syncs to it, thus being restored to the same state. Depending on the configuration changes being applied, it may reboot so the changes can take effect.

When done, both servers’ LCDs display DMA Clustered.

9Log back in as a local admin user and:

a In a two-server cluster, verify on the Dashboard that both servers are up and the private network connection is operating properly.

b Go to Maintenance > Software Upgrade and check the Operation History table.

Polycom, Inc. 385