Polycom 3725-76302-001LI manual Add Device Dialog Box

DMA Operations Guide Endpoints

Note

The Polycom DMA system’s ability to recognize ITP calls and treat them as one assures the same class of service and device authentication settings for all the endpoints in the ITP system, but not other registration settings. It’s up to you to ensure that the maximum and minimum bit rates and other registration settings are consistent.

This capability also doesn’t ensure the availability of sufficient MCU ports for all the endpoints (codecs) in the ITP system. For multi-point conferencing, we recommend dedicating an MCU pool for your ITP system(s).

This capability is only available for H.323.

Follow this naming convention for both the HDX system name and the H.323 name for each HDX endpoint in the ITP system. For more information, see the following documents:

•Administrator’s Guide for Polycom HDX Systems

•Polycom Immersive Telepresence (ITP) Deployment Guide

•Polycom Multipoint Layout Application (MLA) User’s Guide for Use with Polycom Telepresence Solutions

See also:

“Device Management” on page 87 “Add Device Dialog Box” on page 96 “Edit Device Dialog Box” on page 98 “Associate User Dialog Box” on page 101 “Active Calls” on page 87

Add Device Dialog Box

The Add Device dialog box lets you manually add a device to the system.

When you add a device manually, the system applies its registration policy script (see “Registration Policy” on page 268) to determine the device’s compliance level (compliant or noncompliant with the policy), and then applies the admission policy associated with that result to determine the registration status of the device.

The following table describes the parts of the dialog box.

96 Polycom, Inc.