Polycom 3725-76302-001LI manual Field Description, Server

Network Settings Local Cluster Configuration

Table 4-1	Fields on the Network Settings page
Field		Description
System IP type		IP addressing supported (IPv4, IPv6, or both).
System server		Number of servers (1 or 2) in this cluster.
configuration		Caution: Once this is set to 2 server configuration, it
		can’t be changed back to 1 server configuration. To
		reconfigure a two-server system as two separate
		single-server systems, you must use the USB
		Configuration Utility. See the Getting Started Guide.
System split network		Specifies whether management and signaling traffic are
setting		combined on one network interface or split onto
		separate interfaces.
		Caution: Split networking is for network configurations
		in which signaling and management traffic are not on
		the same network. To split the network configuration,
		you must use different gateways and subnets for
		management and signaling, and separate physical
		connections for the management and signaling
		networks (eth0 for management, eth2 for signaling).
		If management and signaling traffic are combined on
		the same network (subnet), both use the same physical
		and virtual IP addresses and the same network
		interface.
Server 1		Status, host name, and IP address(es) of the primary
		server. The IP type and network setting determine which
		of the IP fields in this section are enabled.
		Host names may contain only letters, numbers, and
		internal dashes (hyphens), and may not include a
		domain. The reserved values appserv* and dmamgk-*
		may not be used for host names.
Server 2		Status, host name and IP address(es) of the secondary
		server. The fields in this section duplicate those in the
		Server 1 section and are enabled only in two-server
		configuration.

Polycom, Inc. 65