Cisco Systems 1105 manual Server-Based Security Settings

Chapter 3 Configuring Devices

Using the Templates

Table 3-29 Server-Based Security Settings

	Field	Description
	802.1X Protocol Version (For	Note This setting may cause the device to
	EAP Authentication)	reboot.
		From the list, select one of the following:
		• Draft 7—No radio firmware versions
		compliant with Draft 7 have LEAP
		capability, so you should not need to
		select this setting.
		• Draft 8—Select this option if
		LEAP-enabled client devices that
		associate with this access point use radio
		firmware versions 4.13, 4.16, or 4.23, or
		if workgroup bridges associating with
		this access point use firmware version
		8.58 or earlier.
		• Draft 10—Select this option if client
		devices that associate with this access
		point or bridge use Microsoft Windows
		XP EAP authentication, if
		LEAP-enabled client devices that
		associate with this bridge use radio
		firmware version 4.25 or later, or if
		workgroup bridges associating with this
		access point use firmware version 8.65
		or later.
		Click * (asterisk) for information on which
		version this setting is valid
	Primary Server Reattempt Period	Enter the amount of time a before another
	(Min)	attempt is made if the server is not
		responding.
		Click * (asterisk) for information on which
		version this setting is valid.
	Server Name/IP	Enter the name or IP address of the server.
	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01			3-99