Cisco Systems 1105 manual Specifying Fault Thresholds, Setting Access Point Fault Thresholds

Chapter 2 Fault Monitoring

Managing Profiles

Specifying Fault Thresholds

This option allows you to set polling and exception threshold values collected from the devices you are monitoring.

The threshold values you set in this window will determine how the faults are displayed in the Faults > Display Faults subtab.

Note Your login determines whether you can use this option.

Threshold choices include the following options:

•Access Point—SeeSetting Access Point Fault Thresholds, page 2-15.

•Switch—SeeSetting Switch Fault Thresholds, page 2-17.

•Router—SeeSetting Router Fault Thresholds, page 2-19.

•LEAP—SeeSetting Server Response Time, page 2-19.

•Radius—SeeSetting Server Response Time, page 2-19.

•EAP-MD5—SeeSetting Server Response Time, page 2-19

Setting Access Point Fault Thresholds

Using this option, you can set up thresholds for access point faults. When the thresholds are exceeded, faults are generated and can be viewed under Faults > Display Faults.

Procedure

Step 1 Select any of the following to set values for:

•SNMP Reachable—Go to Step 2.

•RF Port Status—Go to Step 2.

•RF Port Utilization—Go to Step 4.

•RF Port Packet Errors—Go to Step 4.

•RF Port WEP Errors—Go to Step 4.

•RF Port FCS Errors—Go to Step 4.

•Ethernet Port Status—Go to Step 2.

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01		2-15