Cisco Systems 1105 manual Enable-Use this setting to enable STP on, Bridge

Chapter 3 Configuring Devices

Using the Templates

Step 3 Complete the following:

Note Clicking Clear removes all the current entries in the window and any entries you have made in other Template windows up until that point.

Table 3-2 Spanning Tree Protocol Settings

Field	Description
Spanning Tree Protocol	From the list, select one of the following:
(STP)	• Enable—Use this setting to enable STP on the
	bridge.
	• Disable—If you do not want STP enabled the
	bridge.
Always Unblock	From the list, select one of the following:
Ethernet when STP is	• Yes—Use this setting to maintain a bridge link
disabled
	when STP is disabled
	• No—Use this setting to not maintain a bridge
	link when STP is disabled.
	Click see details to see which versions this setting is
	valid for.
Root Configuration

Priority (0-65535)

Enter a number to influence which bridge is designated the root bridge in the spanning tree.

When bridges have the same priority setting, STP uses the MAC addresses as a tiebreaker.

The bridge with the lowest priority setting is likely to be designated the root bridge in the tree.

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-10	78-14947-01