Cisco Systems 1105 ANSI-Use this setting to offer graphic, Features such as reverse video buttons

Chapter 3 Configuring Devices

Using the Templates

Table 3-31 Console/Telnet Settings

		Field	Description
		Baud Rate	Enter a rate from 110 to 115,200, expressed
			in bits per second.
			The rate you enter is dependent on the
			capability of the computer you use to open
			the access point management system.
		Parity	From the list, select one of the following:
			• None—Use this setting to use no parity
			bit.
			• Even—Use this setting to make the total
			number of bits even.
			• Odd—Use this setting to make the total
			number of bits odd.
		Data Bits	From the list, select one of the data bit
			settings.
		Stop Bits	From the list, select one of the stop bit
			settings.
		Flow Control	From the list, select one of the following:
			• None—Use this setting to indicate no
			flow control is used.
			• SW Xonn/Xoff—Use this setting to
			indicate the method information is sent
			between pieces of equipment to prevent
			loss of data when too much information
			arrives at the same time on one device.
		Terminal Type	From the list, select one of the following:
			• teletype—Use this setting if your
			terminal emulator does not support
			ANSI.
			• ANSI—Use this setting to offer graphic
			features such as reverse video buttons
			and underlined links.
	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-108			78-14947-01