Cisco Systems 1105 manual Specify the Http Username, Password, User that you created

Chapter 6 Performing Administrative Tasks

Using Discovery and Managing Devices

Table 6-4 Set Up Procedures for Access Points and Bridges (continued)

Tasks	Procedure		Notes
4. Add an HTTP user	1.	In the Summary Status page, click	This allows configuration uploads
with the ability to		Setup. The Cisco Services Setup	from the WLSE to the access point.
modify firmware, and		page appears.	You must also enter HTTP users
enable the User
	2.	Click Security. The Security Setup	and passwords on the WLSE (see
Manager.
		page appears.	Specify the HTTP Username and
You can use the same	3.	Click User Information; then click	Password, page 6-9).
user that you created
		Add New User. The User
in Task 3, if the user
		Management window appears.
has firmware
	4.	Enter a username and password and
privileges.
		select Firmware; then click Apply.
	5.	Navigate back to the Security Setup
		page and click User Manager. The
		User Manager Setup window
		appears.
	6.	Select Enabled; then click Apply or
		OK.
5. Set up TFTP as the	1.	In the Summary Status page, click	TFTP is used for transferring
transfer protocol		Setup. The Cisco Services Setup	configuration changes to access
between the WLSE		page appears.	points.
and access points.	2.	Under Services, click FTP. The FTP
		Setup page appears.
	3.	Use the pulldown menu to select
		TFTP as the file transfer protocol.
	4.	In the Default File Server text box,
		enter the IP address of the WLSE.
	5.	Click Apply or OK.

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
6-14	78-14947-01