6-13
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Chapter6 Performing Administrati ve Tasks Using Discovery and Managing Devices
2. Enable SNMP.
(Optional) Set the
location.
(Optional) Set the
system name and
system contact.
1. In the Summary Status page, click
Setup. The Cisco Services Setup
page appears.
2. Under Services, click SNMP. The
SNMP Setup page appears.
3. Select Enabled.
4. Enter a System Name, System
Location, and System Contact.
5. Click Apply or OK.
SNMP is required for the WLSE to
discover and manage the device.
Setting the location enables proper
grouping of devices into the
system-defined Location group.
For more information, see
Managing Groups, page 6-37.
Setting the system name and
system location displays this
information when you display
device details.
3. Set the community
string by creating a
user with all
privileges.
(If you already
entered an SNMP
Admin Community
name, the user created
has Write, SNMP,
Firmware, and Admin
privileges, and the
User Manager is
enabled, you do not
need to create another
user.)
1. In the Summary Status page, click
Setup. The Cisco Services Setup
page appears.
2. Under Services, click Security. The
Security Setup page appears.
3. Click User Information; then click
Add New User. The User
Management window appears.
4. To create an user with SNMP
read/write privileges, enter a
username and password and select
the Write, SNMP, Firmware, and
Admin capabilities.
5. Click Apply or OK.
The username of the user with
write and SNMP privileges is used
as the SNMP read/write
community string.
The Firmware privilege is required
for configuring devices from the
WLSE.
Table6-4 Set Up Procedures for Access Points and Bridges (continued)
Tasks Procedure Notes