Cisco Systems 1105 manual Complete the following

Chapter 3 Configuring Devices

Using the Templates

Step 2 Complete the following:

Note Clicking Clear removes all the current entries in the window and any entries you have made in other Template windows up until that point.

Table 3-32 Hot Standby Settings

Field	Description
Hot Standby Mode	From the list, select one of the following:
	• Enable—Use this setting to allow hot standby
	mode.
	• Disable—Use this setting to disable hot
	standby mode.
Service Set ID (SSID)	Enter the monitored access point’s SSID.
MAC Address for the	Enter the monitored access point’s MAC address.
Monitored AP
Polling Frequency (1-30)	Enter the number of seconds between each query
	the standby access point sends to the monitored
	access point.
Timeout for Each Polling	Enter the number of seconds the standby access
(1-600)	point should wait for a response from the
	monitored access point before it assumes that the
	monitored access point has malfunctioned.

Step 3 Select one of the following in the left pane:

•Preview to see your changes before you apply them. (See Previewing the Template, page 3-131.)

•Finish to save the template. (See Finishing the Template, page 3-132.)

•Another template category to configure more options. (See Template Categories, page 3-2.)

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-110	78-14947-01