Cisco Systems 1105 manual Updating Device Firmware Managing Firmware Images

Chapter 4 Updating Device Firmware

Managing Firmware Images

Note Images for Cisco Aironet 350 wireless bridges are listed in the Import window as Cisco Aironet 350 access point images (that is, the names begin with AP). To avoid confusion, you can rename these images after importing them. For more information, see Editing Image Details on the WLSE, page 4-3.

Step 5 To add the image to the Selected Images list, click Add.

Step 6 Repeat steps 4 and 5 to add more images.

Step 7 To remove an image from the Selected Images list, click Remove.

Select the Overwrite Existing Images checkbox if you are importing an image version that is already stored on the WLSE. Otherwise, the image import will fail if the same version is already stored on the WLSE.

Step 8 Click Import. An informational popup window appears. Do not close the popup window until you receive a message that either says the import was successful or the import failed.

If the import is successful, a confirmation message appears and the image is saved on the WLSE.

If the import fails, an error message appears. The import may fail for one of the following reasons:

•The image you are trying to import is not valid. In that case, an error message appears.

•There is insufficient space on the WLSE to store images.

•You specified an image that already exists in the image library and you did not select the Overwrite Existing Image checkbox in Step 7.

Step 9 For information on uploading firmware to access points and bridges, see Managing Firmware Jobs, page 4-9.

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
4-8	78-14947-01