Cisco Systems 1105 manual Remote server settings section, Validate and Save section

Chapter 4 Updating Device Firmware

Managing Firmware Jobs

Step 3 Remote server settings section

If images will be uploaded from a remote TFTP server (instead of being uploaded from the WLSE), complete the Remote server settings section:

Table 4-6 Remote TFTP Server Settings for Firmware Jobs

Field	Description
Use remote server	Select this checkbox to upload the image from a
	TFTP server. The remote server must have a tftp
	server running.
Remote server IP address	Enter the IP address of the TFTP server or select
	a server from the list of recently used servers.
Recently used servers
	Every time you enter a remote server IP address,
	the address will be added to the Recently used
	servers list.
Remote server filename	The filename of the firmware image file on a
	remote server. The image file must reside in the
	main directory for TFTP access on the server.

Step 4 Warnings section

If warnings are detected for any devices during Validate and Save (Step 5), the job will fail for those devices unless you select the Ignore Warnings checkbox. If you prefer not to ignore warnings while the job runs, you can correct the warning conditions instead and then validate again.

Step 5 Validate and Save section

a.Click Validate to verify that the job will run successfully. If you missed one or more of the numbered steps in the left pane, error messages are displayed (for example, Devices not Selected). Correct these errors and click Validate again. The Job Validation Summary window opens. For more formation on this window, see Job Validation Summary Window Details, page 4-17.

Note It is recommended that you always validate a job before saving it. Also, you should check the image release notes on Cisco.com for the latest caveat information on the image.

	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01		4-15