Cisco Systems 1105 manual Access point or bridge, Have firmware rights, Community string on

Chapter 8 Troubleshooting

Table 8-2 Troubleshooting Hints for Configure (continued)

Feature	Symptom	Probable Cause	Possible Solution
Configure > Jobs	An HTTP job does	The credentials are not set	Make sure the credentials on
	not run or fails.	properly.	the WLSE are the same as
			the credentials on the access
			point or bridge using
			Administration > Discover
			> Device Credentials.
			Make sure the credentials on
			the access point or bridge
			have firmware rights.
		The TFTP server is not	The TFTP setting on the
		set up correctly.	access point should point to
			the WLSE as its TFTP
			server. This can be done by
			applying a template
			configuration, containing
			TFTP server settings,
			through an SNMP job (only
			11.08T and higher)
	The device is not	HTTP browsing is	At the access point console,
	responding to HTTP	disabled on the AP	turn on non-console
	jobs.	because of this job run.	browsing, or schedule an
			SNMP job for the device if
			its version is11.08T or
			higher.
	An SNMP job does	The community string is	Make sure the SNMP
	not run or fails.	not set properly.	community string set on the
			WLSE is the same as the
			string set on the access point
			or bridge using
			Administration > Discover
			> Device Credentials.
			Make sure the SNMP
			community string on the
			access point or bridge has
			firmware rights.
	User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01				8-5