Peak Labeling
If peak list filtering is enabled, only the detected peaks that meet the peak filtering criteria are labeled according to the peak label settings. Otherwise, all detected peaks are labeled according to the peak label settings. See Section 3.2.4, Peak Detection Parameter Descriptions, and “Filtering the spectrum peak list” on page
To delete a peak label from the trace, click the Spec Peak List tab in the Output window, select the item,
If a label is not displayed or is displayed incorrectly, possible causes are:
•The label is too long, peaks are too close together, or a peak is very close to the right axis. If there is not enough room for the label to be displayed, the label is suppressed. Zooming the region of interest expands the trace and may allow the labels to display.
To display labels when peaks are close together, select | 3 |
Allow overlapping peak labels in the Peak Label dialog |
|
box. |
|
•Peak filtering is enabled, labeling only peaks that meet the peak list filtering criteria.
•Filter Width is set too high to detect the peak.
Data Explorer™ Software User’s Guide |