Manipulating Traces
NOTE: You must select the Use same settings for all traces check box before selecting options for traces. If you do not, settings are applied only to the active trace.
5. In View Setup, select Overlay Trace scaling: |
| |
• | Display Relative— Autoscales each trace to the |
|
| base peak in the display range |
|
• | BP Relative— Autoscales each trace to the base | 2 |
| peak in the trace | |
•Absolute Value— Maintains scaling of individual traces
6.Set trace colors as needed:
•If you selected Use same settings for all traces, click Autocolor to allow the software to automatically assign trace colors.
NOTE: The active trace color stays at its original setting. Other trace colors are set based on the active trace color. For example, if the active trace is yellow, other traces are assigned the colors pale blue, pale green and medium gray, which are the colors listed after yellow in the Trace color list, excluding white. White is not used in Autocolor, because white may not print on certain printers.
•If you did not select Use same settings for all traces, click Graph Setup, then select trace colors. See “Setting colors” on page
7.Click OK.
Data Explorer™ Software User’s Guide |