Yamaha 4-axis model, 3-axis model owner manual 22 ZFL

Chapter 8 SXYX

3-7 ZFL

(Arm type, moving arm type, 3rd-axis option/XZ type 2- axis model)

When using the 3rd-axis model with ZFL for the 3rd-axis, install the workpiece onto the ZFL slider in the following manner.

Six M5 coarse thread tap holes and a φ5 reamer hole are opened on the slider's workpiece installation surface. Install the tool using these holes. Six M5 coarse thread tap holes are opened on the slider side. Use these as required to fix light loads other than the tool, such as the wiring retainer.

110

100

(Tolerance between knock (0.02)

70±0.0243

9 9

10 6-M5⋅0.8 Depth9

8	18
70
156	120
70	50

2-φ5H7 Depth15

6-M5⋅0.8 Depth12

1 9

Stroke cover

Fig. 8-22 ZFL

Select the maximum nominal length of the tool fixing bolt so that the screw fit- ting length is 12mm or less.

YAMAHA recommends a screw fitting length of 8mm or more.

!CAUTION

If the bolt fitting length is 12mm or more from the installation surface, the bolt will contact the bottom.

8-18