Yamaha 4-axis model, 3-axis model owner manual Whipover cable user-wire specifications

Chapter 10 HXYX

4-2 Whipover cable type

!CAUTION

Do not clamp the wires or tubes to the outside of the independent cable. The independent cable could sag or break and ultimately be disconnected.

The signal wires (0.3mm2 ⋅ 7 wires) and air tubes (4 ⋅ 2.5, 2 tubes) are incorpo- rated in the Whipover cable. Use these to wire and pipe to the tool.

Part No.	Part name	Part No.	Qty.
1	SM connector	SMR-10V-B	1
2	SM connector	SMP-10V-BC	1
3	Contact	SYM-001T-0.6	7
4	Contact	SHF-001T-0.8BS	7
5	Cable		1

P

BK

t

qe

I/O

Signal Connector NO

General-	I/O	1
purpose	q	2
I/O		3
		4
		5
		6
		7
		8
		9
		10

NO Connector		Remarks
1	I/O	Brown
2	w	Red

3Orange

4Blue

5Purple

6Gray

7White

10

P

BK

wr

I/O

	R	R
ORG	Y Z	Y Z

ORG

M	M
Air tube	Air tube
Controller side	Tool side

Fig. 10-18 Whipover cable user-wire specifications

4-2-1 Examples of wiring and piping with Whipover cable

!CAUTION

Securely crimp the pin and insert into the pin connector.

Failure to do so will prevent the signals and power from being supplied cor- rectly, and may prevent the device from operating correctly.

1)Crimp the user's cable and tool wiring onto the enclosed connector.

Refer to section “1-2. User I/O wire” in Chapter 5 “Specifications” for de- tails on the enclosed connector and pin specifications.

Recommended crimping tool YC-122R (J.S.T. Mfg Co., Ltd.)

2)When using an air tube, prepare an air coupler for connecting the user air tube with the YAMAHA air tube.

10-22