Yamaha 3-axis model Installing and removing the cover Stroke cover, Removing the stroke cover

Chapter 12 HXYLX

5-5 Installing and removing the cover

5-5-1 Stroke cover

Removing the stroke cover

1)Remove the fixing screws (M4, pan-head) on both ends.

2)Place the table slide near the stroke end, and pull off the cover.

Side cover Center cover Motor block Table slide End block

Installing the stroke cover

1)Place the table slide near the stroke end, and pass the cover between the table slide and motor block.

2)Fix the cover to the end block. At this time, move the table slide to the stroke center, and confirm that it does not interfere with the cover. If the table slide interferes with the cover, adjust by tightening the cover fixing screw. (Refer to following photographs.)

When cover contacts table slide

⇒Tighten the cover fixing screw

When cover contacts motor block

⇒Loosen the cover fixing screw

12-27