Yamaha 3-axis model, 4-axis model owner manual 14 ZL

Chapter 10 HXYX

3-5 ZL

(Arm type, gantry type, moving arm type 3rd-axis option/ XZ type 2-axis model)

When using the 3rd-axis model with ZL for the 3rd-axis, install the workpiece onto the ZL slider in the following manner.

Eight M6 coarse thread tap holes and two φ6 reamer holes are opened on the Y-axis slider. (Refer to Fig. 10-14.) Install the user tool onto the ZL slider using these holes.

Four M5 coarse thread tap holes are opened on the side of the slider. Use these to fix loads other than the tool, such as the wire retainer.

2-φ6H7 Depth8

23.5

19

			45
70	124	140	50

8-M6⋅1.0 Depth8 110

		(Tolerance between knock (0.02)	4-M5⋅0.8 Depth7
		135
	20	90	20
(Allowable screw depth)	6 (Thread insert depth)
8

Fig. 10-14 ZL

!CAUTION

If the fitting length is less than 6mm, the threads could be damaged during tightening. If the fitting length is longer than 8mm, the end of the screw could contact the cover stroke.

NOTE

There is a step on the top of the slider. The actual tool installation surface is the shaded section shown above.

Select the nominal length of the bolt for fixing the tool so that the screw fitting length is 6mm or more, 8mm or less. (Refer to the cross-section drawing in Fig. 10-14.)

10-15