Yamaha 3-axis model, 4-axis model owner manual Installing the Cover

Chapter 11 FXYBX/SXYBX

6 Installing the Cover

If the X-axis stroke is long, a slider mechanism is provided in the X-axis stroke cover. The alignment of the slider and upper cover must be adjusted when install- ing the cover.

Target FXYBX X stroke 2150mm or more

SXYBX X stroke 2450mm or more

!CAUTION

If the slider and upper cover are not correctly adjusted, the slider could be damaged prematurely.

When inserting into the U-character groove, take care not to cut the slider with the edge of the cover.

1)Turn the controller power OFF.

2)Insert the slider into the U-character groove on the center of the upper cover. Set the upper cover so that it is parallel with the axis movement direction at this time.

Slider travel groove

Slider

3) Temporarily fasten the four upper cover installation screws, move the table from the motor side to the counter-motor side end, and then completely tighten the screws on the counter-motor side. Move the table to the motor side again, and then completely tighten the two upper cover installation screws on the motor side.

4) Move the slider by hand to check that it travels along the upper cover smoothly.

11-21