Yamaha 3-axis model, 4-axis model owner manual 11-5

Chapter 11 FXYBX/SXYBX

1)Remove the four M4 screws from the top of the X-axis wiring box, and loosen the M4 screw on the end face.

Remove

X-axis wiring box

Loosen

Fig. 11-6

2)Open the X-axis wiring box cover.

Lift up the back of the wiring box, push it forward and then pull it upward and off.

Fig. 11-7 Opening the wiring box

3)Connect the ground wire to the ground terminal attached to the top of the X-axis wiring box.

An M4 small screw with spring washer and lock washer are attached to the ground terminal. Arrange the parts in the order of the lock washer, ring-tongue terminal and M4 small screw with spring washer, and then tighten. (Refer to Fig. 11-8.)

M4 small screw with spring washer

Ring-tongue terminal

Lock washer

Fig. 11-8

11-5