Yamaha 3-axis model, 4-axis model owner manual User Wiring and User Piping

Chapter 12 HXYLX

4 User Wiring and User Piping

WARNING

Always turn off the controller before wiring and piping to prevent electri- cal shocks.

4-1 Cable carrier type

A cable carrier is mounted as a standard between the X and Y axes. When 3rd- axis are used, a cable carrier is also provided between the Y and Z axes, and when using 4th-axis, a cable carrier is also provided between the Z and R axes. Lay the wiring and piping to the tool using these ducts. A 0.3sq 10-core flexible cable is wired from the X-axis wiring box to the final axis wiring box, and can be used freely. The wiring and piping methods for a 2-axis arm type are explained below as an example.

4-1-1 Example of wiring and piping methods using cable carrier

1)Remove the four M4 small screws and open the X-axis wiring box (fixed) cover.

2)Pass the required cables and air tubes, etc., through the cable lead-out port on the X-axis wiring box (fixed).

Cable lead-out port

Fig. 12-12

12-15