Yamaha 4-axis model, 3-axis model owner manual Tool installation ZH

Chapter 10 HXYX

3-4 ZH

(Arm type, gantry type, moving arm type 3rd-axis option/ XZ type 2-axis model)

!CAUTION

If the fitting length is less than 9mm, the threads could be damaged during tightening. If the screw length exceeds 27mm from the installation surface, the screw could contact the bottom.

When using the 3rd-axis model with ZH for the 3rd-axis, install the workpiece onto the ZH frame in the following manner.

M6 coarse thread tap holes are opened on the frame's workpiece installation sur- face. Install the tool using these holes. The tap depth is 10mm.

Select the under head length of the installation bolt so that the screw length from the installation surface is 9mm or more, 27mm or less.

Refer to the XY-X Series catalog for the installation position.

22

17 10

100

78

22

Fig. 10-13 Tool installation ZH

NOTE

There is a step on the ZH frame.

The actual tool installation surface is the shaded section shown above.

10-14