A-31
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
AppendixA Command Reference
APS Commands
associate group
To enter APS configuration subcommand mode and to associate interfaces for APS protection, or to
modify the attributes of an existing APS group, use the associate group command. To remove the group,
use the no form of this command.
aps group-name
no aps group group-name
Syntax Description
Defaults None
Command Modes Redundancy configuration
Command History
Usage Guidelines Use this command to create an APS group, or specify an existing group, and enter APS configuration
mode. You can specify group names created with this command or with the associate interface
command.
Examples The following example shows how to select an APS group and ente r APS configur ation m ode .
Switch# configure terminal
Switch#(config)# redundancy
Switch#(config-red)# associate group blue
Switch#(config-red-aps)#
Related Commands
group-name Specifies a group name for the interface pair. Group names are case
sensitive and cannot have embedded blanks.
Release Modification
12.1(10)EV2 This command was first introduced.
Command Description
apsclear Clears APS switchover or lockout.
aps direction Modifies path switching behavior.
aps disable Disables APS activity between associated interfaces.
aps enable Enables APS activity between associated interfaces.
apslockout Prevents switchover to the protection interface.
aps revertive Enables revertive behavior for line card protection.
apsswitch Requests an APS switchover.
aps timer message holddown Modifies the hold-down timer for APS Channel Protocol messages.