4-16
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter4 Configuring ESCON Signal Aggregation
Configuring Patch Connections
Note If you correctly patch your cards, patch command configuration is not necessary for t he signal t o pass
from the client to the trunk fiber.
Example
The following example shows how to configure t he patch connec tions betw een line ca rds in a shelf wit h
two OSC cards in slot 4, two OADM modules with OSC in slot 0, and a splitter 10-Gbps ITU trunk card
in slot 3:
Switch# configure terminal
Switch(config)# patch thru 0/0 thru 0/1
Switch(config)# patch wave 4/0 oscfilter 0/0
Switch(config)# patch wave 4/1 oscfilter 0/1
Switch(config)# patch wavepatch 3/0/0 filter 0/0/1
Switch(config)# patch wavepatch 3/0/1 filter 0/1/1
Displaying Patch Connections
To display the patch connections, use the following privileged EXEC command:
Note The error field in the show patch command output helps tr oub lesho ot sh elf m iscon figurati ons. W he n
there is a channel mismatch between a transponder card and an OADM module, Channe l Mi sma t ch
appears for the patch connection. When more than one OADM module drops the same channels,
Channel Mismatch appears for all patch connections.
Example
The following example shows the patch connections:
Switch# show patch
Patch Interface Patch Interface Type Error
--------------- --------------- ---- -----
Thru0/0 Thru0/1 USER
Wave3/0 Oscfilter0/0 USER
Wave3/1 Oscfilter0/1 USER
Command Purpose
show patch [detail] Displays the patch connections.