A-223
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
AppendixA Command Reference
Threshold Commands
threshold-list
To create a list of thresholds, or modify an existing threshold list, use the threshold-list command.
Todelete the threshold list, use the no form of this command.
threshold-list name
no threshold-list name
Syntax Description
Defaults None
Command Modes Global configuration
Command History
Usage Guidelines Use this command to create a list, or modify an existing list, of signal degrade and signal failure alarm
thresholds for monitored error counters. After entering the command, the CL I enters thresh old
configuration mode where you can specify the threshold list attributes or thr eshol d count ers to a dd or
modify.
Before deleting a threshold list, remove it from all the interfaces that use it.
Examples The following example shows how to create a threshold list called t emp.
Switch# configure terminal
Switch(config)# threshold-list temp
Switch(config-t-list)#
Related Commands
name Specifies the name of the threshold list to be created and associated with a
specified interface.
Release Modification
12.1(10)EV2 This command was introduced.
Command Description
aps trigger Enables APS switchover when the alarm threshold is crossed.
description Specifies a threshold description for the SNMP MIB.
notification-throttle timer Modifies the alarm threshold notification throttle timer.
show threshold-list Displays the contents of a threshold list.
snmp-server enable traps
threshold min-severity Enables SNMP trap notifications for alarm threshold activity.
threshold Creates failure and degrade thresholds for different error counters that
are monitored on the interface.