A-133
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
AppendixA Command Reference
OSCP Commands
Related Commands
OSCP St Shows the OSCP Hello state. Valid values are:
•down—the physical layer is down
•attempt—the physical layer is up, but no Hello messages have been
received from the neighbor
•1-way—Hello messages have been received from the neighbor, but their
content indicates that the neighbor has not yet received Hellos from this
node.
•2-way—Hello messages have been received from the neighbor indicating
that the neighbor has received Hello packets from this node.
Bndl Shows the bundling identifier, which identifies the wavelength bundle to the
remote node for the link. The bundle identifier is carried in the OSCP Hello
packet. The configured bundle identifier is used to derive an identif ier that both
the host and remote nodes agree on.
By default, all links have a zero (0) value. Because all links have the same
default value, all links between the host and remote nodes are aggregated into
a single logical link (with bundle identifier0).
To assign a non-default bundle identifier to a link between two nodes, only one
side has to be configured with the non-default value.
The default value 0 indicates that the host node uses the bundle identifier o n
the remote node.
Valid values are 0-255.
Note The bundling identifier is supported in this release.
Pri Shows OSC selection priority. When multiple links are present in the same
wavelength bundle, the link with the highest priority value is selected as t he
active OSC link. The OSC link transmits all control and network management
traffic for the entire wavelength bundle to the remote node.
Only links that have a LinkHelloState value of “two-way” can be the active
OSC link. If more than one link has the highest link priority, the selection is
arbitrary. To ensure that a specific link is chosen to be the active OSC link, its
priority value must be higher than all other links.
Valid priority values are 0-255.
Note The OSC selection priority is supported in this release.
Rem Port ID Shows the port ID for the remote port.
Rem Node Id Shows the node ID for the remote port.
TableA-23 show oscp interface Field Descriptions (continued)
Field Description
Command Description
show oscp neighbor Displays OSCP neighbor information.
show oscp statistics Displays OSCP activity statistics.
show oscp traffic Displays OSCP message traffic informatio n.