4-4
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter4 Configuring ESCON Signal Aggregation
Configuring ESCON Multiplexing Line Card In terfaces
Example
The following example shows how to display the configuration of an esconphy in ter face:
Switch# show interfaces esconphy 7/0/0
EsconPhy7/0/0 is down, line protocol is down
Signal quality:Loss of light
Client Laser Status:Down due to Request from Remote
Forward laser control:On
Flow-identifier:40
Configured threshold Group:escon
Threshold monitored for:8b10b cvrd
SF set value:10e-3 (20000 in 1 secs)
Threshold monitored for:CRC
SF set value:10e-3 (19999 in 1 secs)
Received Frames:0
Transmit Frames:0
Code violation and running disparity error count(cvrd):0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
CRC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Egress Packet Sequence error count:0
Egress Packet Indicated error count:0
5 minute input rate 0 bits/sec, 0 frames/sec
5 minute output rate 0 bits/sec, 0 frames/sec
Hardware is escon_phy_port
The following example shows how to display the configuration of a portgroup i nte rface :
Switch# show interfaces portgroup 10/0/0
devt_ham_03/11#sh in portgroup 10/0/0
Portgroup10/0/0 is up, line protocol is up
Transmit Packets: 883067943
Received Packets: 887268737
Code violation and running disparity error count(cvrd): 247499080
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
CRC error count: 3
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
CDL HEC error count: 0
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
SII Mismatch error count: 0
ESCON Protocol Mismatch error count: 0
Hardware is portgroup