A-138
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
AppendixA Command Reference
OSCP Commands
show oscp traffic
To display OSCP (Optical Supervisory Channel Protocol) Hello message traffic information, use the
show oscp traffic command.
show oscp traffic [wave slot/subcard]
Syntax Description
Defaults Displays OSCP Hello message traffic information for all OSC wave interfaces in the system.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command to display OSCP control traffic statistics, which show the count of different protocol
packets that have been transmitted over the optical supervisory channel.
Examples The following example shows how to display OSCP control traffic statistics, which show the count of
different protocol packets that have been transmitted over the optical supervisory channel. (See
Table A -26 for field descriptions.)
Switch# show oscp traffic wave 3/0
OSC Traffic Statistics:
interface Wave3/0
Description Count
~~~~~~~~~~~~ ~~~~~~~~~~
Tx IP pkt 0
Rx IP pkt 0
Tx CDP pkt 198
Rx CDP pkt 195
Rx pkt dropped 0
wave slot Specifies an OSC wave interface.
Release Modification
12.1(10)EV2 This command was introduced.
TableA-26 show oscp traffic Field Descriptions
Field Description
Tx IP pkt Shows number of IP packets that have been transmitted over the optical
supervisory channel.
Rx IP pkt Shows number of IP packets that have been received over the optical
supervisory channel.