4-12
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter4 Configuring ESCON Signal Aggregation
About Alarm Thresholds
Example
The following example shows how to configure a cross connection between an ESCON multiplexing line
card and a 10-Gbps ITU trunk card:
Switch(config)# connect portgroup 2/0/0 waveethernetphy 3/0.1
The following example shows how to configure a cross connection between an ESCON multiplexing line
card and a 10-GE uplink card:
Switch(config)# connect portgroup 2/0/0 tengigethernetphy 3/0.1

Displaying the Cross Connection Configuration

To display the cross connection configuration, use the following privileged EXEC command:
Examples
The following example shows the cross connections within a system for an ESCON signal:
Switch# show connect
Index Client Intf Trunk Intf Kind C2TStatus T2CliStatus
----- --------------- --------------- ----------- ---------- ---------
15 Port3/0/0 WaveE8/0.1 Provisioned Up Up
The following example shows the cross connections within a system for a transponder signal:
Switch# show connect intermediate
client/ wave wave wdm
wave client patch filter trk channel
------------ ------------ ------- ------ ----- -------
Trans7/0/0 Wave7/0 7/0/0* 0/0/0 0/0 25
7/0/1
About Alarm Thresholds
You can configure thresholds on ESCON multiplexing line card, 10-Gbps ITU trunk card, and 10 - GE
uplink interfaces that issue alarm messages to the system if the thresholds are exceeded.
Every second, the monitoring facility updates the counters that correspond to the alarm thresholds. When
the signal degrades, or fails entirely, the system issues alarms to the console. These alarms can help
isolate failures in the system and in the network.
Command Purpose
show connect [edge | intermediate [sort-channel |
interface interface]] Displays the signal cross connection
configuration through the system.