Service Tests and Utilities
35Press any key to shutdown the printer.
Cutter test
The Cutter is designed to cut roll media after printing for the size of sheet defined. Before executing this test you should run the Scan Axis, Media Drive and Carriage tests to ensure that each of these subsystems is operating correctly.
Perform the Scan Axis - Cutter test as follows:
1In the Diagnostics menu, scroll to 1. Scan Axis and press OK.
2The Front Panel will show the 1. Scan Axis submenu.
3In the Scan Axis submenu, scroll to Cutter and press OK to start the test.
The Printer will start the Scan Axis subsystem Common Initialization and Cutter test initialization. If there is a Failure at any point during the tests, the Front Panel will display the relevant System Error Code. To trouble shoot any displayed error codes, see System Error Codes - Full Descriptions on page
4The printer then starts the Cutter test to verify the subsystem. As the test executes the Front Panel displays the following messages:
Starting Horsburgh and Mips.
Starting Nvm.
Starting TestsGpio.
Getting Part Number.
Starting SvsMotor.
Starting CarriageMotor.
Starting ServiceStation.
Starting ScanAxis
Moving SVS to rear bump.
Homing Scan Axis.
Move Carriage out of SVS path.
Homing Service Station.
Starting ServicingServices.
Capping Service Station.
HP Designjet T Series — Service Manual |