Removal and Installation - Belt Assembly

Belt Assembly

Removal

Switch off the printer and remove the power cable.

1. Remove the Carriage Assembly. See page 6-116 or 6-127 depending on the printer model.

2. Slide the Belt Assembly out of the attachment on the Carriage Assembly.

3. Remove the pulley to release the Belt Assembly from the Belt Tensioner.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page 6-5.

HP Designjet T Series — Service Manual

6-141