Service Tests (Diagnostics)
Starting Horsburgh.
Starting Nvm.
Accessing Nvm.
Starting AdcManagerHorus.
Starting Carriage.
Getting Carriage PCA Rev.
3The Front Panel prompts you to verify the Carriage Assembly PCA revision. The PCA Rev must be between 0.949 and 1.161.
4If the results are correct, press OK to accept the results. If the results are not correct, press Back/Cancel to reject the results and FAIL the test.
5The Carriage Assembly test starts and the Front Panel displays the following messages followed by their results:
Getting Num of pens.
Getting Scan Access size.
Getting Vs Carriage Voltage.
6The Front Panel then displays the Carriage Voltage (+Vs) test results. The +vs Voltage should be between 30.6 and 33.3 for T1120/T1120ps or between 43.6 and 46.3 for T1100/T1100ps/T610.
7If the results are correct, press OK to accept the results. If the results are not correct, press Back/Cancel to reject the results and FAIL the test.
8The Carriage Assembly Vaux test starts and the Front Panel displays:
Getting Vaux Carriage Volt.
9The Front Panel then displays the Carriage Voltage (+Vaux) test results.
10Press any key to continue.
11The Carriage Assembly Pens Voltage test starts and the Front Panel displays:
HP Designjet T Series — Service Manual |