Removal and Installation - Print Zone Overdrive

Print Zone Overdrive

Removal

Switch off the printer and remove the power cable.

1. Remove the Starwheel Assembly on page

6-208.

The Print Zone Overdrive is in two sections (left and right). This procedure describes the removal of both of the sections. If you only want to remove one of the sections skip the steps for the other section.

2. Remove one T-15 screw that secures the left clamp of the Print Zone Overdrive to the Platen.

3. Lift attachment clamp vertically to release it from the Platen.

HP Designjet T Series — Service Manual

6-210