Removal and Installation

Trailing Cable (T1100/T1100ps/T610)

Removal

Switch off the printer and remove the power cable.

1. Remove the Left Cover on page 6-30.

2. Remove the Right Cover on page 6-27.

3. Remove the Front Panel on page 6-47.

4. Remove the Top Cover on page 6-50.

5. Remove the Window Position Sensor on page 6-53.

6. Remove the Ink Supply Tubes Support Rail (T1100/T1100ps/T610) on page 6-55.

7. Loosen the T-10 uncapping screw sufficiently so you can manually move the

Carriage Assembly in step 7.

If you are uncapping a 44 inch printer, you will need to use either a very long or very short screwdriver to loosen the uncapping screw. In this way, you can loosen the screw and pass the rewinder motor.

44 inch T1100 printer shown (with Rewinder)

8. Push the Carriage Assembly into the print path.

6-102

HP Designjet T Series — Service Manual