System Error Codes

 

System Error:

45:YZ

Problem

An error with the Rewinder System has been detected.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Check that the Rewinder cable is not damaged and is correctly connected to the PrintMech PCA.

3Check that the Right Spindle Holder (rewinder included) is correctly attached to and aligned with the Right Cover.

4Perform the Rewinder diagnostic test to troubleshoot the problem further. See 6. Rewinder on page 3-34.

5Replace the Right Spindle Holder (rewinder included). See Right Spindle Holder and Rewinder (T1120/T1120ps) on page 6-87 or Right Spindle Holder and Rewinder (T1120/T1120ps) on page 6-87.

6If the System Error continues, replace the PrintMech PCA. See PrintMech PCA (T1100, T1100ps, T610 ONLY) on page 6-73.

System Error:

47:03

Problem

Star wheels motor error.

Description:

 

Corrective Action: Try the following:

„Same as 47:YZ. The error is continuable, but only if it happens from time to time.

System Error:

47:YZ

Problem

Star wheels motor error.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Check that the Starwheel Assembly cable is not damaged and is correctly connected to Main PCA.

3Open the Window and check for any visible obstacles restricting the movement of the Starwheel Assembly, then clear the obstruction.

4Perform the Scan Axis Starwheel diagnostic test to troubleshoot the problem further. See Star Wheel Lifter test on page 3-7.

5Replace the Starwheel Motor. See Starwheel Motor on page 6-245.

6If the System Error continues, replace the Main PCA. See Starwheel Assembly on page 6-208.

2-18

HP Designjet T Series — Service Manual