Removal and Installation - Right Roll Guide

Right Roll Guide

Removal

Switch off the printer and remove the power cable.

1. Remove the Spindle on page 6-79.

2. Remove the Clean Out Assembly on page

6-90.

3. Remove the Left Roll Guide on page 6-94.

4. Remove seven T-15 screws that secure Right Roll Guide to the printer.

5. Lower the right end and remove the Right Roll Guide from the printer.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page 6-5.

HP Designjet T Series — Service Manual

6-95