System Error Codes - Full Descriptions

System Error:

48:YZ

Problem

PPS system failure.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Check that the Pen to Paper Space (PPS) Solenoid cable is not damaged and is correctly connected to the PrintMech PCA.

3Perform the Scan Axis PRS diagnostic test to troubleshoot the problem further. See PRS Test on page 3-9.

4Make sure the Service Station is correctly installed. Sometimes, if the Service Station is not correctly installed, the front of the Service Station falls down (causing the Service Station to be tilted), and the L-Bracket support does not fit properly. The front of the Service Station should be “UP,” and the L-Bracket should fit well with the Service Station.

5Replace the Pen to Paper Space (PPS) Solenoid. See Pen to Paper Space (PPS) Solenoid (T1100/T1100ps/T610) on page 6-75 or Pen to Paper Space (PPS) Solenoid (T1120/T1120ps) on page 6-77.

6If the System Error continues, replace the PrintMech PCA. See PrintMech PCA (T1100, T1100ps, T610 ONLY) on page 6-73.

System Error:

51:YZ

Problem

Window Sensor failure.

Description:

 

Corrective Action: Try the following:

1Check that the Window Position Sensor cable is not damaged and is correctly connected to the PrintMech PCA.

2Perform the Sensors Test to troubleshoot the problem further. See 5. Sensors on page 3-31.

3Replace the Window Position Sensor. See Window Position Sensor on page 6-53.

System Error:

52:10

Problem

The printer has detected fibers in the Drop Detector.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Check that the Drop Detector cable is not damaged and is correctly connected to the PrintMech PCA.

3Clean the drop detector.

4Check that the Service Station cable is not damaged and is correctly connected to the PrintMech PCA.

HP Designjet T Series — Service Manual

2-19