Removal and Installation - Right Spindle Holder and Rewinder (T1120/T1120ps)
Installation
When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page
Make sure you carry out the following actions during the installation of the Right Spindle Holder (rewinder included)
1. Take note of the two clips that fit to the printer.
2. Make sure the two clips fit correctly to the printer.
3. A correctly attached Right Spindle Holder (rewinder included) looks like this (shown from above).
View shown from above.
HP Designjet T Series — Service Manual |