System Error Codes |
|
System Error: | 87:YZ |
Problem | Problem finding the |
Description: |
|
Corrective Action: Try the following:
1Upgrade the firmware.
2Clean the Encoder Strip.
3Replace the Encoder Strip. See Encoder Strip, spring and attachment nut (T1100/T1100ps/T610) on page
4Replace the Carriage PCA. See Carriage PCA (T1100/T1100ps/T610) on page
5Replace the Trailing Cables. See Trailing Cable (T1100/T1100ps/T610) on page
System Error: | 93:YZ |
Problem | Unable to pressurize the Ink Delivery System. The ISS Motor does not move |
Description: | as expected. |
Corrective Action: | Try the following: |
1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.
2Perform the Ink Delivery System diagnostic test to further troubleshoot the problem. See 7. Ink Delivery System (IDS) on page
3Replace the Left Ink Supply Station, depending on the results of the diagnostic test. See Left Ink Supply Station on page
4After replacing the Left Ink Supply Station, if the problem persists replace the Main PCA. See Electronics Module Main PCA and PSU (T1100/T1100ps/ T610) on page
System Error: | 94:YZ |
Problem | Color calibration Error. |
Description: |
|
Corrective Action: Try the following:
1Profiling failed due to a different error (not algorithm / data processing).
2Perform the Line Sensor calibration. See Troubleshooting, Line Sensor. See The Line Sensor has Problems Detecting Media on page
3If the System Error continues, replace the Line Sensor. See Line Sensor (T1100/T1100ps/T610) on page
4If the System Error continues, replace the Carriage PCA. See Carriage PCA (T1100/T1100ps/T610) on page
HP Designjet T Series — Service Manual |