Service Calibrations
2When the following message appears on the front panel, you must select whether you would like to continue with the calibration by pressing the OK key. Press Back or Cancel to exit the calibration.
3If media is not loaded, the following message appears on the front panel. Load media in to the Printer and start again from step 1.
Before continuing, the Printer will check the following:
The Media Lever is in the lowered position.
The correct paper type is loaded (check list on previous page).
The correct paper size (minimum paper size 24 inches).
If these conditions are not met, a warning will be displayed on the Front Panel and you will need to restart the Calibration from step 1.
Make sure you keep your hands away from the Print Platen as the Carriage will be moving at high speed and you could injure yourself or damage the Carriage Assembly.
4The printer will start to calibrate the Line Sensor. Once the Line Sensor has been calibrated, the results will be displayed on the Front Panel. Press OK to continue or press Back or Cancel to exit the calibration.
If the values are not within the range specified, an error will appear on the Front Panel. In this case, try the following:
Try the
Replace the Line Sensor
5The Printer will start to calibrate the Line Sensor position to the Black Printhead. The Front Panel displays the following message:
Line Sensor to Black calibrating
HP Designjet T Series — Service Manual |