Removal and Installation - Full Bleed Foam
Full Bleed Foam
Removal
Switch off the printer and remove the power cable.
The complete Full Bleed Foam is constructed of three separate sections, left, center and right. This procedure only describes how to remove the left section. Removal of the other two sections is identical.
1. Open the Window.
2. Remove the Left Full Bleed Foam from the left platen.
3. Remove the Platten Middle Foams that are exposed once the Full Bleed Foam has been removed.
When you reinstall the full bleed foams, take care to correctly seat them to avoid possible damage to the Carriage Assembly
HP Designjet T Series — Service Manual |