System Error Codes - Full Descriptions
Code | Recovery Action | Response | |
|
|
| |
10 | Replace |
| |
|
|
| |
11 | Reseat/Reconnect/Clean/Adjust (manually) |
| |
|
| hp qualified | |
12 | Calibrate/Adjust (using Automatic Process) | ||
personnel | |||
|
| ||
|
| ||
13 | Power OFF | assistance | |
|
| required | |
14 | Upgrade System Firmware | ||
| |||
|
|
| |
15 | Upgrade Driver or Computer Software |
| |
|
|
| |
16 | Add Accessory |
| |
|
|
| |
17 | Escalate |
| |
|
|
| |
18 | Send Plot Again |
| |
|
|
| |
19 | Wrong Part Installed |
| |
|
|
|
System Error Codes - Full Descriptions
| This sections describes each of the system error codes and warnings that |
| could be encountered while using the printer and provides the remedial |
| action required to solve the problem detected. |
| Only replace one component at a time and check if the |
| error has gone before replacing another component. Using |
| this procedure you will be able to determine exactly which |
| component failed. |
System Error: | 01.0:YZ |
Problem | Communication with Main PCA failed. |
Description: |
|
Corrective Action: Try the following:
1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.
2Remove the formatter and reinsert it again. Ensure that it connects properly in the Main PCA connector.
If the System Error continues, replace the Main PCA. See Electronics Module Main PCA and PSU (T1100/T1100ps/T610) on page
If the System Error continues, replace the Formatter. See Formatter on page
HP Designjet T Series — Service Manual |