System Error Codes - Full Descriptions

4If the System Error continues, replace the Trailing Cable and Carriage PCA Covers. See Trailing Cable (T1100/T1100ps/T610) on page 6-102 or Trailing Cable (T1120/T1120ps) on page 6-109.

5If the System Error continues, replace the Carriage PCA. See Carriage PCA (T1100/T1100ps/T610) on page 6-173 or Carriage PCA (T1120/ T1120ps) on page 6-178.

6If the System Error continues, replace the Main PCA. See Electronics Module Main PCA and PSU (T1100/T1100ps/T610) on page 6-202 or Electronics Module Main PCA and PSU (T1120/T1120ps) on page 6-205.

7Replace the Carriage Assembly. See Carriage Assembly (T1100/T1100ps/ T610) on page 6-116 or Carriage Assembly (T1120/T1120ps) on page 6- 127.

System Error:

03:YZ

Problem

Problem with Power Supply Unit.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Perform the Electronics Module Test Diagnostic to troubleshoot the problem further. See 3. Electronics Module on page 3-21.

3If the System Error continues, replace the Power Supply Unit (PSU). See Electronics Module Main PCA and PSU (T1100/T1100ps/T610) on page 6-202 or Electronics Module Main PCA and PSU (T1120/T1120ps) on page 6-205.

System Error:

03.0:10

Problem

Battery of Real Time Clock ran down.

Description:

 

Corrective Action: Replace the battery:

1Turn the printer off and unplug the cable. Unplug any network or USB cables.

2Loosen the screws that attach the formatter to the printer with your fingers, or with the help of a flat screwdriver, and remove the formatter.

3Locate the round, flat battery in the formatter.

4Push the battery slightly to one side and then pull it up. A little force may be required.

5Insert the new battery by pressing it down.

6Insert the formatter into the printer by pressing it down, and tighten the screws.

7Reconnect the cables and turn the printer on.

HP Designjet T Series — Service Manual

2-9