Removal and Installation

Clean Out Assembly

Removal

Switch off the printer and remove the power cable.

1. Remove the Spindle on page 6-79.

2. Disconnect the Out Of Paper Sensor in-line connector and unroute the its cable.

3. Remove the four T-15 screws that secure Clean Out Assembly to the printer.

4. Beginning with the left side, slide the Clean Out Assembly out of the printer. Double check that you haven´t broken the Out Of Paper Sensor on the left side of the

Clean Out Assembly.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see

Service Calibration Guide to Removal and

Installation on page 6-5.

6-90

HP Designjet T Series — Service Manual